Neotech Bridge^®

Visit our YouTube channel for more Neotech videos.

Click here to read our Frequently Asked Questions.

Step 1 Fill syringe with milk or formula and twist onto the purple Neotech Bridge connector.

Step 2 Invert the Bridge and center over the nipple. Fold Bridge down onto the breast to create a seal.

Step 3 Latch the baby onto the Bridge.

Step 4 Depress syringe to deliver milk as needed.

Step 5 Clean and sanitize regularly as directed. Replace Bridge after one week or 20 washes, whichever is sooner.

Cleaning
Step 1 Separate and rinse all parts, including syringe plunger, under running water to wash away milk residue.

Step 2 Soak all separate parts in warm soapy water for 5 minutes.

Step 3 Reinsert the plunger into the syringe and fill with warm soapy water. Connect to Bridge and extension tubing (if used). Flush and repeat several times.

Step 4 Fill syringe with clean water and reconnect to Bridge and extension tubing (if used). Flush and repeat several times.

Step 5 Fill syringe with air and reconnect to Bridge and extension tubing (if used). Force air through tubing several times to remove water droplets.

Step 7 Disconnect all parts, including syringe plunger, and place on a clean, dry surface and allow to air dry. Store dry parts in plastic bag/container when not in use.

Caution: Do not dry the components with paper towel or similar as this will shorten the life of the device. Do not store wet or damp parts.

Sanitizing
Sanitize once daily. Do not use sterilizers or microwave.

Step 1 Separate and rinse all parts, including syringe plunger, under running water to wash away milk residue.

Step 2 Fill a pot with 8 cups of drinking-quality water and bring to a boil.

Step 3 Turn off heat source and let boiling water cool for two and a half minutes.

Step 4 Place the separate parts into the water and allow them to soak for 10 minutes.

Caution: Do not heat parts above 94 degrees Celsius or 201 degrees Fahrenheit as this could cause the parts to deform and prevent the Bridge from functioning properly.

Step 5 Allow water to cool in open pot and gently remove parts from water with tongs.

Step 6 Place parts on a clean, dry surface and allow to air dry. Store dry parts in plastic bag/container when not in use.

Caution: Do not dry the components with paper towel or similar as this will shorten the life of the device. Do not store wet or damp parts.

INDICATIONS FOR USE

The Neotech Bridge is a breastfeeding assistance device intended to deliver supplemental nutrition to an infant latched at the breast/chest.

CAUTIONS & WARNINGS

The Bridge should not be used if there is an existing medical contraindication for breastfeeding. If unsure, check with your physician.

Do not allow supplement contents to dry in the syringe before washing.

Separate and wash all parts that come in contact with the breast, breastmilk, or supplement immediately after use to avoid dry up of milk residues and to prevent growth of bacteria.

Only use drinking-quality tap or bottled water for cleaning.

Do not scrub components of the syringe as this will shorten the life of the syringe.

Do not heat parts above 94 degrees Celsius or 201 degrees Fahrenheit as this could cause the parts to deform and prevent the Bridge from functioning properly.

Do not dry the components with paper towel or similar as this will shorten the life of the device. Do not store wet or damp parts.

Follow cleaning instructions provided by Neotech unless advised otherwise by your healthcare professional.